Toronto Scissor Lift Certification

Toronto Scissor Lift Certification - Many worksites and tradespeople such as iron workers, welders and masons use scissor lift platforms in order to help them reach elevated work places. The operation of a scissor lift is usually secondary to their trade. Thus, it is vital that all platform operators be trained well and certified. Industry, lift manufacturers and regulators all work together to be able to ensure that operators are trained in safely utilizing work platforms.

Work platforms are likewise called manlifts or AWPs. These equipment are stable and easy to use, though there is always some danger because they lift people to heights. The following are some key safety issues common to AWPs:

To protect those working around work platforms from accidental power discharge due to close working proximities to power lines and wires, there is a minimum safe approach distance (MSAD). Voltage can arc across the air and cause injury to personnel on a work platform if MSAD is not observed.

Care must be taken when lowering a work platform to guarantee steadiness. The boom should be retracted, if you move the load toward the turntable. This will help maintain steadiness when the -platform is lowered.

The rules about tie offs do not mandate those working on a scissor lift to tie themselves off. Some organizations would on the other hand, need their employees to tie off in their employer guidelines, job-specific risk assessments or local regulations. The manufacturer-provided anchorage is the only safe anchorage wherein harness and lanyard combinations must be attached.

It is essential to observe and not exceed the maximum slope rating. The grade can be measured by laying a straight edge on the slope or by laying a board. After that, a carpenter's level can be placed on the straight edge and raised until the end is level. By measuring the distance to the ground and dividing the rise by the length of the straight edge, then multiplying by 100, you can determine the percent slope.

In order to determine whether the unit is mechanically safe, a regular walk-around check must be performed. Work site assessments are also essential to make sure that the work area is safe. This is essential especially on changing construction locations because of the chance of obstacles, unimproved surfaces, and contact with power lines. A function test should be performed. If the unit is utilized safely and properly and proper shutdown measures are followed, the chances of accidents are really reduced.

Click to Download the pdf